New Kates Playground Galleries

AC unit in the 12V solar system

you have decided to purchase a solar system and you want to install themselves on the roof of your RV?

First, you should be concerned about the position of the solar system RV thoughts. The photovoltaic system should ideally be installed so that it is designed parallel to the direction of travel. This has the advantage of the wind turbulence is minimized, also provides such an installation, a lower target for branches that might be caught under the solar panels. The Solara module mounts ABB made of hardened material and provide both a secure connection between mobile home roof and solar modules as well as protection for the solar modules.

first Connect solar panel and solar module mounting

First, the solar panel mounts are connected to the photovoltaic modules. This shall be the spoiler on a flat surface and fits on the solar panels. With a pen to mark the holes in the solar panel and drilled before this. Now, the solar panel is fixed to the brackets with stainless screws.

second Solar module fixed on the roof

The screwed-together parts (bracket and panel) should now be placed on the roof. Preferably with ruler first determine the exact position of the solar system on the Motorhome. Draw the outline of the solar roof spoiler on the surface of the motor home with a pen. Remove the bracket including solar panels and clean them first place at which the solar spoilers are to be glued to the roof. Now enter the glue in the marked areas, and then position them holding spoiler including solar modules at the appropriate points.

third Cabling of solar modules

If you install more than a solar panel on the roof of Womo they must connect these accordingly. Before they start, they should, however, the connection between the roof surface and the solar module support can dry out completely. For easier handling, the solar modules of the screw will now be released again from the support. In the parallel circuit of the solar modules should be a safe, spill-proof and tensile strength to connect. Best solves this with Y-connectors. They offer 2 inputs and one output, and thus can be a cabling complete within minutes. When wiring should always rely on solar cable, as this is UV and heat resistant and is designed for outdoor use.

4th Roof duct on the Womo

the roof duct should be installed in an optimal way near a bay. So as to avoid a complex wiring inside the camper. The indicated point on the roof of the camper, drill two holes for the cable, or alternatively from the inside of the camper top drill. Now position the roof duct, mark and replace the special adhesive. The roof duct position and let dry. Then pull the cord.

5th Charge Controllers

the charge controller inside the camper mount and connect the cables of the solar system. Then connect the solar controller with on-board battery. The charge controller should be installed where possible in the vicinity of the battery to the cable between the solar controller and batteries to keep it under two meters. Now connect the solar controller with the battery.